Blogroll

Powered by Blogger.

Tuesday, 30 September 2014

Modify 2*2*2 LED Cube Circuit to Turn on LED 3 only (Part 4 of 13)

by realfinetime  |  in LED Cube at  18:58

<<<<  Read Previous Part (Part 3)

          We had already seen the internal circuit of 2*2*2 LED cube in the last blog. Here, we will make some modifications in the circuit to turn on LED 3 only.

          If the circuit is done as given above, LED 3 will turn on. Positive terminal of 5V cell is connected to the anode terminals of LED 1, LED 2, LED 3 and LED 4 through a current limiting resistor of 1K. Negative terminal of 5V cell is connected to the cathode terminals of LED 3 and LED 7. From these two connections, we can conclude that the only LED which get both positive and negative voltages is LED 3. This will turn on LED 3.

Continued in Next Part (Part 5)  >>>

3 comments:

  1. You have a genuine capacity to compose a substance that is useful for us. You have shared an amazing post about Test And Tag Adelaide.Much obliged to you for your endeavors in sharing such information with us.

    ReplyDelete
  2. Thanks for your post. It's very helpful post for us. You can also visit test tag perth for more Victor Steel related information. I would like to thanks for sharing this article here.

    ReplyDelete
  3. I generally check this kind of article and I found your article which is related to my interest. Genuinely it is good and instructive information. Thankful to you for sharing an article like this.Led screen panel india

    ReplyDelete

IMPORTANT NOTICE

All the circuits, published in this blog is only after testing and getting proper results in my private lab. When you try these circuits, you should check the supply voltage, polarity of components, presence of childrens nearby and shorts in the circuits. This website will not be responsible for any harm happened to you or your components caused by your carelessness.

For More Electronic Tips



Blog Archive

Proudly Powered by Blogger.