Blogroll

Powered by Blogger.

Friday, 31 July 2015

Temperature on seven segment display using LM35 and arduino uno

by realfinetime  |  in Seven Segment Display at  01:40

We had already seen the circuit to measure the temperature using LM35 and arduino in one of my previous blog. Here, we will see the video demonstration of working of LM35 using arduino uno. Temperature measured will be displayed in a 5 digit seven segment display. Here, we are bringing a hot soldering iron near LM35 to increase the temperature around LM35.
Watch the video demonstration here.

3 comments:

  1. Hey, Your post is very informative and helpful for us. In fact i am looking this type of article from some days. Thanks a lot to share this informative article.
    You can also see this MicFlip: World's First Reversible Micro USB Cable .

    Thanks

    ReplyDelete
  2. Although all soldering relies on the same principles, the techniques and tools you use may vary depending on the type of materials you're soldering and the kind of outcome you're intending.

    Kevin Nelson || www solderingironguide com

    ReplyDelete
  3. After a long time, I read a very beautiful and very ismportant article that I enjoyed reading. I have found that this article has many important points, I sincerely thank the admin of this website for sharing it. Best Gas detectors in Abu Dhabi service provider

    ReplyDelete

IMPORTANT NOTICE

All the circuits, published in this blog is only after testing and getting proper results in my private lab. When you try these circuits, you should check the supply voltage, polarity of components, presence of childrens nearby and shorts in the circuits. This website will not be responsible for any harm happened to you or your components caused by your carelessness.

For More Electronic Tips



Proudly Powered by Blogger.